This awesome mount holds both your VTX and receiver antenna wires. It puts them in the perfect spot for reception while also keeping them out of the props during flying or landing….aka…crashing. They’re made from flexible TPU material. This allows a crumple zone without putting stress on the wires or connectors.
This mounts up using the two back canopy screws. It gets sandwiched in between the frame and canopy. One nice benefit we noticed after the design was printed was, the mount also acts a “keeper” for your screws while taking the canopy off. Since the holes are smaller then the screws, they stay in place on the frame so you don’t lose them.